Colour Guard - Red Stain

Colour Guard is a dual action formula that combines a penetrating concrete stain and a durable sealer in a one easy-to-use product. This innovative 2-in-1 solution offers unparalleled protection and aesthetic enhancement for all your porous concrete surfaces.

Colour Guard is suitable for both interior and exterior use, and sets a new standard in concrete staining and surface protection. Attainment of a darker and richer colour with subsequent coatings.

Colour Guard is specifically tailored for porous cementitious products. It is important to note that Colour Guard will not be effective on cementitious products with residual oil or waxy residue, as the is creates a barrier that prevents adequate penetration. Colour Guard can not be used on previously painted surfaces.

DIRECTIONS FOR USE:

Colour Guard is specifically tailored for porous surfaces in need of a penetrating colour stain and reliable protection. 

• Do not dilute.
• Shake well before use.
• Conduct a preliminary test in a discreet area before commencing the full application.
• Thoroughly review all instructions to ensure precise planning and execution.
• Take necessary precautions to shield adjacent surfaces requiring protection during application.
• Verify desired outcomes in an inconspicuous area before proceeding with the complete application.
• Ensure the work area is clean and devoid of any dust, wax, oil, grout, cement, or other blemishes.
• Allow ample drying time for the surface before applying Colour Guard ; surface must be bone dry.
• During the spray application, maintain a distance of 20-30cm from the target area to ensure that Colour Guard is applied evenly without drift.
• Use a sweeping motion and apply overlapping passes to ensure an even coverage without excessive build-up.
• Allow approximately 4 - 6 hours for the coating to dry before considering additional coats.
• Apply a minimum of 2 coats.
• Allow 24 hours after final coat to cure

APPLICATION GUIDELINES AND PRECAUTIONS:

• Employ a tool such as pressure pump spray bottle for the application process.
• Avoid application in direct sunlight or on hot surfaces.
• Colour Guard is water-based. To clean tools, simply rinse them under warm water. Wash with mild soap and warm water, and rinse thoroughly until the water runs clear.
• Avoid spraying on windy weather conditions, as this can cause drift, affecting non-target areas.

Pro Tip: When using Colour Guard on a large area, it is advisable to use multiple bottles from the same batch number to prevent potential colour variations. Alternatively blend bottles before application.

COVERAGE:

50 square meters per 5L

STORAGE:

Ensure the cap is tightly sealed, and store the product upright. Store in a cool, secure location, out of reach of children. Dispose of empty containers responsibly, do not repurpose containers. Discard the product 18 months after the batch date.

SAFETY INSTRUCTIONS:

• Exercise caution and avoid using Colour Guard in areas where surface water may induce slippery conditions.
• Keep the product out of reach of children and pets. Avoid contact with eyes, mouth, and skin. Utilize appropriate personal protective equipment as required.
• In the event of eye contact, promptly flush with water for a minimum of 15 minutes. If ingested, seek immediate medical attention without inducing vomiting. For skin contact, cleanse with soap and water and seek medical aid if irritation persists.
• Store in an upright position and utilize Colour Guard within the recommended temperature range of 5° C – 30° C

DISCLAIMER:

While Crystal Guard products undergo rigorous testing procedures, the company cannot assume liability for damages, whether direct or consequential, resulting from product usage due to the absence of direct oversight during application. 

We offer a wide selection of colours. The colour and shade of the substrate will effect the tone of the finish. Results may vary.